Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a SG350-10 which suddenly started acting up one day to the next (at least i am not aware what I changed while it was still running).Its my office switch so it gets powered up and down a lot, while the other ones I have (including another 35...
Hi, Firmware Version (Active Image):2.5.0.78 I have a SG350X-24MP on which I want to use Jumbo Frames on a 10G interface (XG2) to be precise.I have globally enabled Jumbo Frames and rebooted the switch. I test this connection between appropriately co...
Hi,
I have a SG350X which is connected to a Mellanox 6036 in Ethernet mode via a 4:1 splitting cable.
The Port on the Cisco is complaining about a Duplex mismatch every 5 minutes.
Since this is a 10G Port, no manual duplex configuration can be pe...
Hi,
I have recently got two SG350XG-2F10's which I set up as a vertical stack (A).
They are going to replace two Netgear switches which are also set up as vertical stack (B)
While I am migrating settings I wanted to connect the SG350's with the N...
