Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We had an issue the other day where a port channel was blocked due to a "SPANTREE-2-RECV_PVID_ERR". We have a port channel (channel-group 42) configured on this switch with 8 ports. This port channel is configured as a trunk and those 8 ports are tie...
I am just struggling to find a reason why a port channel that is connected to an ESXi host would have a spanning tree issue when hosts/vSwitches don't even participate in STP. The vSwtich drops STP frames also, so it isn't even possible for a VM to r...
Yea
@Reza Sharifi wrote:
What is the purpose of this command?
switchport access vlan 4
If vlan 4 supposed to be the native vlan than the command should be
switchport trunk native vlan 4
HTH
I actually need to find that out. I didn't understand the ...
Here are relevant port channel and interface configs. Both are on the same switch and like I said the other end of both of these port channels is an ESXi host. Everything is consistent below.
interface Port-channel41 description ESX03 switchport sw...
