Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am using this switch in my lab for testing. There are no other layer 3 devices in my lab besided this switch. if I go ahead and set up my VLANs, can I still use access lists to allow or deny connectivity between different ports (devices) on differe...
When I try to lauch PDM on my PIX 501 by typing the ip address of the PIX in IE, I receive the following error:The startup wizard is not supported on the FWSM.These are the versions:Cisco PIX Firewall Version 6.3(5)Cisco PIX Device Manager Version 3....
I have a problem with resetting my PIX 501 firewall password. Since I inherited this from a previous Engineer who did not leave any documentation I don't know what the IP address for inside and outside interfaces are. I would like to use it in our la...
Hi: I know this is an older router but I am using in my lab for testing purpose.Origianally I had a problem upgrading the IOS image because I received message from the router saying the system flash not writable. So I found the article describing wha...
Hi Hank:Thanks for your response.I upgraded from Java 2 Runtime Environment 1.4.2_03 to Java SE Runtime Environment version 6 Update 1. I will let you know if I still get the error message after the upgrade or not. Thanks
Thanks for your response.So you are saying by going to the monitor mode and typing "interface 0" and then "address 192.168.10.100", I will be basically overwriting the previously-assigned Ethernet0 IP address with the new IP address (192.168.10.100)?...
I have a similar problem with my PIX 501 firewall. I don't know what the IP address for inside and outside interfaces are.Any chance somebody could tell my how to recover (reset) the password.Basically I connected the Ethernet0 port of my PIX to a sw...
