Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i have an issue with a NAT configuration. The setup is that there is dynamic NAT using a pool of a single host that maps many users to a public IP. There is also a web server that has a static NAT mapping.The problem is that the customer is using ...
Hi,i have a 2651XM router running 12.3.7-T8 code thats is configured as an IOS FW. There is one public NAT entry for an OWA server. If i enable the sudit signatures inbound on the WAN interface, i cannot connect to the OWA server using HTTPS. No sign...
Hi,i have a 3725 router with a NM2W holding two daughter cards, a WIC1-T and another WIC-2T. By default on insertion they have come up with clock rate 2000000, which cannot be removed. I am trying to connect using V.35 MTE cable to the provider which...
Im trying to set up a 3640 router with a 4B S/T and digital modem card as an out of band management solution. A number of our routers have US Robotics 56k modems connected to their aux ports, and I would like to have a central OOB router to dial them...
HI,im trying to clear some config up for CBWFQ. The docs state that allocated bandwidth to classes should total no more than 75% of available bandwidth.But what about when you are defining bandwidth with the bandwidth percentage command? Should all c...
Thanks for all your help, ive had my customer change the DNS entry. I tried the PBR to no avail as a test but it was only a 2M link so wouldnt have been a long term fix anyway.I get the inside to outside interface idea, but i still think this behavio...
I can work around this issue changing the internal DNS; i know its the way it should be set up anyway, but i just think its a bit lame to say to my customer that im sorry, Cisco says no.Thanks.
From all the other reading ive been doing, it seems that the alias command on a PIX could do this job using DNS fixup. Is there a version of these commands on IOS FW?Everyone seems to be saying that the above setup just isnt possible, which i find pr...
Thanks Mak, but i cant find an IOS that supports the modem dialout BRI command? Cant find it on command lookup either... Its a 3640 were tryingt on, have tried right up through 12.2 Enterprise feature set with no luck. Is it a special release?Thanks ...
SOrry, i need a bit more information than that. BRI config looks ok to me (basic, but if you say no PPP needed then its just and sh isdn stat is fine)!interface BRI1/3 no ip address no ip directed-broadcast isdn switch-type basic-net3 isdn incoming-v...
