Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey Group,Has anybody seen a problem where you have ip ospf network point-to-multipoint enabled (with OSPF neighbor statements) on an interface that is actually in an ethernet broadcast segment and get the error to many DBD retransmitions. The probl...
We have a situation where some equipment did not come in and we are trying to bring up a circuit that was going to be GigE over SONET end to end but isn't possible at this time. What we are going to try is to have a 7200 router with a GigE interface...
Yeah we have static neighbors all ready setup there in the config. What we are thinking is that OSPF is messed up with sending and receiving both unicast and multicast. We had to set up the point-to-multipoint configuration because we need to a way...
yeah the mtu isn't the issue, all the interfaces are set to 4096 and MPLS doesn't come into play because OSPF doesn't come yet so nothing would be MPLS Switched. But these are directly connected and would only be sent IP switched to the directly con...
Actually what I meant by local loop is to have the CSU go into local loop mode and look at the router. The data stream will be sent out the router to the CSU/DSU through the loop and right back at the same router. If you do a show interface on the ...
The CDVT isn't something that you would want to change because it is supposed to match the default of the size of the interface for the ATM connection. If it is set to high the equipment will violate the CAC and you will get cell clumping which lead...
