Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've configured outside and inside interfaces. I can ping the inside interface from my laptop, which is connected directly to ethernet1, and I can ping the outside world from the PIX. However, I can NOT ping the outside world from my laptop. Am I ...
I once came across a cisco configuration analyzer for PIX firewalls. For the life of me, I can't find it anywhere on the cisco site. Does anyone know where it is? Thanks.
I'm trying to construct a serial cross-over cable to simulate a connection between a cisco 2610 and 1605 router. I think the cross-over pins are 1-7 and 2-8. Can anyone confirm this is correct? Thanks.
I'm trying to configure the speed on a wic-dsu-56k module from a 1605 router by using the service-module command. However, it does not work on this module. I'm trying to set the speed to 64k....supposedly this wic module can support that speed........
Thanks, Doug...however, I'm not able to browse either from my laptop. I'm using dhcp on the inside only. I configure the outside interface with a default route and assigned a DNS address to the outside interface. What could I have missed? Thanks ...
I got the command to work....I get a warning: 64k mode will not work in back-to-back DDS.I'm newbie to all of this. Any help would be greatly appreciated.Thanks.
Thanks for the response, smif. When i type in the command i'm getting an "invalid input" error at the -.I'm not sure what command i'm supposed to enter.
Doug, thanks for the reply. In a perfect world, I'd like to replace the Sonicwall appliance with the PIX. However, the Sonicwall is handling voice traffic. I'm not sure If I can completely do away with it....I have no experience with the Sonicwall...
