The main thing's when you configure static route you need to begin by connecting all site and be able to ping all site on both sides by declaring the next hop which will help you to reach the remote site, just when you have finished this work you can...

Hi, Don't break your brain go into config mode try command (config)#ip ?  if you can see   route                 Establish static routes   routing               Enable IP routing this means your switch is Layer 3 but it doesn't exist make sure you ar...

The Best command to see simply if portfast is enabled for example on port fastethernet 1/0/1 S1#show spanning-tree detail | s Port 1 S represents section  1 is the number or tag of your interface  For my example look the result switch_off_vau#sh span...