About kenny.wallrath1

kenny.wallrath1 · 10-23-2018

Hi together, I currently face problems with connecting iPhones to a guest SSID with open Layer 2 security and layer 3 Web Policy on passthrough. We discover that a connection to the SSID is possible by clicking the Accept button on the WLC-Portal...

kenny.wallrath1 · 10-30-2018

Hi Maurice,we're having the same issue on our ME controllers as well. I also didn't found a right switch for this problem.What helped was, changing the hours manually and refresh to check if NTP is still in sync. From now it seems to work in this way...

kenny.wallrath1 · 10-25-2018

Yes you can assign an interface directly to a physical port. But you need to assure to disable LAG mode on the WLC, first. Under "Controller -> Interfaces -> *your-interface-name*" you find a point "Physical Information" where you can assign the inte...

kenny.wallrath1 · 10-25-2018

Hi, I think you are looking in the wrong MIB. Try to check out the Airespace MIB "AIRESPACE-WIRELESS-MIB" There you also have a section with your QoS Rates.

kenny.wallrath1 · 10-24-2018

I do not think this is possible on PI. When we needed to change the IPs we added the WLC as it was a new Device.

kenny.wallrath1 · 10-23-2018

I once wrote a script to monitor a similiar issue about knowing if all APs are up.If you are using some SNMP Monitoring try to look into the following OID on the WLC: 1.3.6.1.4.1.14179.2.2.1.1 (bsnAPEntry)http://www.oidview.com/mibs/14179/AIRESPACE-W...

Member Since	‎02-06-2018 12:14 AM
Date Last Visited	‎07-06-2023 06:08 AM
Posts	11
Total Helpful Votes Received	10

User Statistics

User Activity

iPhones on Open SSID with Web Policy need to reconnect

Re: Mobility Express stuck in DST

Re: Can we use multiple ports on Cisco 2504 controller for multiple virtual lan

Re: SNMP monitoring data flow per SSID returning disabled

Re: Cisco Prime LAN Management Solution

Re: How to identify the offline AP?