Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Any info on this issue will be greatly appreciated, my level of knowledge is low when it comes to VPN’s. Here is my current issue, I currently have a PIX 506 with VPN enabled on it, some users connect remotely with the Cisco VPN client software. N...
hi,Simple question really. I have a PIX515 and backup the config using an TFTP server. Now my question is can I restore the config on a 505? I'm not using the DMZ interface on the 515. This is purely for a quick backup solution in case of a crash. Le...
Hopefully someone will be able to help me out on my issue. I have two (2) PIX 501's between two (2) offices with a VPN connection. In one of the offices the users use remote desktop to connect to the other office. I’m using restricted licensing on th...
Hopefully someone will be able to give me a hand with this issue. Basically I wanna swap my 501 with a 505 I've configured it properly (I think I did). When I plug it in the network I can ping my ISP router, but my servers on the inside cannot access...
Thanks for the quick reply Andy. I typed in the following command "sh local-host" and I noticed the output from that command that there were 10 connections established and there was a maximum of 10. I did a "clear local-host {IP}" on a connection tha...
I pointed the default gateway of my machine to the new pix. When I type "sh arp" I see the entry for my machine and my ISP's router. The old PIX is still connected, how can I make sure that it is not proxy-arping?
