Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Guysjust found something puzzling on my inside interface ....(MSFC Behind the FWSM ...inside interface is shared with the MSFC) and i noticed a lot of drooped packets on the input interface and its increasing by the millisecond is this normal ?pleas...
Hi guys Please is there any link on CCO that clearly states the conversion between PIX and ASA of clearly shows how the commands changed.Any other gotchas on the conversion.your Inputs will be appreciated.RegardsHash
hello Netpro,I have a pix in a customer and it keeps restarting every 15 min-17 mins , I brought another 515E and install there with the same configuration but it keeps rebooting also. Does anyone has any idea on this?TIAHashQA-FW> sh verCisco PIX Fi...
Hi NetProTrying to setup a Site to Site VPN to allow remote site access to the DMZ, checked cisco.com Site could not find any Sample configuration using the "command line" any pointer on the Site or Sample configs will be appreciated.RegardsHash
Dharmesh,Thank you for your response, the mapping on the link you sent to me is for PIX not ASA though alot of the commands are the same but i learnt that there are other differences in them.what do you advice
thank you Jon,Will try that and get back to you. thought there was no need sine the SSL DC adds the "route 0.0.0.0 0.0.0.0 10.6.78.1" by itself. as shown on this linkhttp://www.cisco.com/en/US/products/hw/switches/ps708/module_installation_and_config...
Gilles,thank you for your response, the SSL-DC by itself added the "route" command ro the configuration. i.e. route 0.0.0.0 0.0.0.0 10.6.78.1or did you mean i should add "ip route" just as in the IOS ?all i need is telne/ping access to the SSL-DC.TIA...
Hi Gilles/Everybody,had a problem with the SSL access via telnet as shown on the Documentation. I have created a VLAN (SVI) on the MSFC, and Created the same VLAN (server VLAN) on the CSM Module and equally on the SSL_DC all on the same subnet, with ...
oh sorry the default is p2p because when u type the commandint s0/0.1 and then enable the encapsulation the the sh run display will show that the interface is p2p even though u did not state it .good luck hashiru
