Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Configuration file is also attached with queryI am having problem when configuring Voice and data Vlan on a single port.What I am doing that when we configure the below commands it works fine.VLAN for Voice is 20VLAN for Data is 24SVIs are configure...
Explanation: If we have a scenario like our data center and their 100 branches , they all have public IP addresses and on internet link and not mpls or data connectivity, so in that case do dmvpn supports?
No it does not matter because there are multiple switches where this problem is arising. I just showed one of them. Secondly the reason of showing that screen was that was no information about register value in the show version command of this type o...
so it means there is no other option (other than open and closed mode) after my ISE VM down. one of the two options must be defined in order to remain the users connected to the Network
