I have one question and I will try to keep it simple.
I have a Catalyst 2960-CG Series switch.
The model I have is WS-C2960CG-8TC-L.
There are 8 Gigabit Ethernet interfaces with Ethernet only connections.
There are 2 interfaces (9 and 10) that ...
Hello,
I am trying to pin point and ultimately resolve an intermittent OSPF adjacency issue. I have been looking at it for a little while now. Throughout my troubleshooting I had to turn on some ospf debugging, send the debugs to the log, and incre...
I have been tasked with troubleshooting the cause of an HSRP 5 STATECHANGE that is happening intermittently between two production routers:
Feb 13 22:50:15.961: %HSRP-5-STATECHANGE: GigabitEthernet0/0 Grp 0 state Standby -> ActiveFeb 13 22:50:18.51...
Thank you for the reply.
I configured the interface per your suggestion but it is still not working. I know the command is working because the RJ45 connection no longer works when I plug into it. Could this be a SFP compatibility issue?
My fiber guys tell me that the fiber has been swept and that it is not a problem. This is why I was asking. I see someone else just replied with some commands. I will give those a shot. Thanks for the reply.
Hello,
I was out yesterday. I am picking this back up.
Here is the config on the primary HSRP router that tracks the object:
#sh run int gigabitEthernet 0/0Building configuration...
Current configuration : 376 bytes!interface GigabitEthernet0/0...
