Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey Team,This is a NDFC Multisite Setup where NDFC is a virtual cluster running latest version.I got existing Core Routers on each site,Core routers are in production providing L3 ServicesCore routers connect site-1 and site-2 as well and provide Lay...
Hi Team,
I got 4 Nexus Dashboard Nodes. That i am setting up with for telemetry with Cisco ACI in a multipod setup.
What would be the most suitable way to place the ND appliances.
2 Master Nodes in POD1 and 1 Master + 1 worker Node in POD 2.
Also to...
Hi,
Have a Cisco Nexus Dashbaord with Insight. integrated with Cisco ACI. in the System Status Details, i see Telemetry Configuration Status "N/A"
Any idea why?
thanks
Nadeem
Hi,
In a multipod setup, the inband addresses will be from same subnet or differnet subnets for POD1 and POD2. There is just one inband EPG/BD. would it make sense to have two subnets in that BD?
thanks
Nadeem
Hi Team,
Trying to configuration EPL in my lab using CML. I have a basic 1Spine - 2 LEAF topology.
NDFC virtual appliance is running on ESXi with MGMT and DATA interfaces.
DATA interface can ping its default GW.
When I enable EPL, it picks the Serv...
Hi,
Thanks for sharing this. We used the json script for controller 1, however the same script (with modification for controller 2 and 3) cant be used, it says "Code: 400 Message: Node 1 must be present in bootstrap cluster request"
It looks like we ...
Hey Guys, if you can run these commands on the APIC Cli moquery -c aaaServiceNodeCluster moquery -c telemetryStatsServerPand see if you get some objects. in case you get the objects you need to delete them
I figured it all out, no one replied: Do I use “monitor mode” to add the core routers. If I uncheck the monitor mode and import brownfield, what will be the impact of it to the existing production configuration. -> I tried both ways. I would prefer...
