Hi:
I am not able to see the loopback of R6 (6.6.6.6) in R1. I can see it in R2 but I dont know why it is not being redistributed into R1. There is a BGP session in between R1 and R2 and OSPF 1 in between R2 and R3 - R4.
R1#show run | sec routrou...
Hi guys:
This is my first post. I was playing a bit with gns3 and I found out a problem. I have a virtual link in between 2 routers (R8 and R11) that is not comming up. I checked the debug and seems that the DBD is not being sent but I dont know wh...
No no because they are in a central area that is area 2. Anyway I left it flapping for like 5 min and suddenly it started working without problems. Probably the dead timers need to synchronize or something I dont know but now is working fine aparentl...
Logs from R10 and R9:
R10#*Mar 1 00:23:21.689: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to down*Mar 1 00:23:21.697: %OSPF-5-ADJCHG: Process 2, Nbr 8.8.8.8 on Serial0/0 from FULL to DOWN, Neighbor Down: Interface down...
Hi Georg:
Thanks for the answer. I made the change as you said and it came up for a few seconds but it dropped again as the connection in between R10 and R11 seems to be flapping. I checked the configuration on both routers and seem to be ok.
I ...
