Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We upgraded the firmware on our 3504 to 8.10.151.0. The aps we are using are 2802's. We are getting errors in the logs stating that the ap's are not reachable to wsa server. How can I make it so they stop trying to connect? Below is a few lines of ...
I have about 50 2800 AP's in our building. On one of these AP;s I recently set the 2.4GHz radio to Monitor mode. Almost immediately, clean air detected interference on 5GHz listed as Wifi Inv. Channel. In addition, we also have a newly installed C...
Screen shot shows what I see in WLC web console, when going to Monitor>Cisco CleanAir> 802.11a/n/ac>Interference Devices/
DevID and clusterID are shown. In this example, the clusterID of the top two detection are the same, but the Device ID is di...
