Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, Dahernan
If you want to make router adjacency then no used "no passive-interface" command on that interface in which both routers are connected to each other to make adjacency. By default passive-interface is on in every interface in routers...
Hello, ThomaslthorneIt's IOS compatibility issue that for sure. you must used ASA 9.x IOS to configure EIGRP v3.if you learn more about this open below Cisco site link. https://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-genera...
Hello, Georg Pauwen
you are saying right it would work perfectly. But i think on real network scenario ISP not doing this thing. To configure default route to own end to reach customers.
The best way to configure same routing protocols in both end ro...
Hello,
Above question we discuss the packet format. Below i try to explain that point, which one you want to understand.
1) How we know fragmentation is already done or not ?
2) How did you find out total length kindly tell me in detail ?
