Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anybody explain why the Black Hole Mitigation feature changes the default 100kmicrosec beacon interval to a "slightly lower value" (usually 99 or 98 kmicrosec) ? I am rather baffled by this very slight change - where is the advantage to black hol...
A very basic question, which just popped into my mind during a config session (and perhaps I will make a fool of myself Why is that the static WEP key is 128-bit in Cisco APs and clients if only 26 hex characters need to be entered ? According to my...
During testing of our new AP1220 with g module, I became curious about the data rate settings and how they can affect throughput/coverage. There are three pre-set modes (Best Range, Best Throughput and Default).I tested all three modes. The results w...
I'm slightly baffled with your question. CCK is the modulation used in any case for 11M (either 11b or 11g AFAIK). The "sharing" in wireless is about Rx and Tx time on the AP. So if you have 11b clients in your 11g network, they will reduce your wire...
From your response it seems to me that you equal WinCE and Win2003Mobile OSs. The Win2003 Mobile is, as far as I know an upgrade/add-on to Windows CE .NET 4.2. Does that mean that drivers for Windows CE .NET 4.2 work also for Win2003Mobile ?Thanks,Ma...
Hi Toni !The most certain way to make it work only for 11g clients is to disable all 11b rates on the AP (e.g. 1,2,5.5 and 11 Mbps), or to set at least one 11g speed at required (6 Mbps) and 11b speeds to enable (no basic/required), yet the latter mi...
Another thought just crossed my mind. If you need the correct authentication on the correct SSID just for the purpose of assigning VLANs, you can use per-user RADIUS assigned VLANs.Best regards,Mark
Firmware 5.30.17 supports WPA. ACU 6.2 supports WPA in a limited fashion, i.e. only LEAP is supported for WAP (no WPA-PSK or WPA with EAP-TLS/PEAP). Another WPA supplicant could be used to achieve other WPA auth modes.BR;Mark
