About rpalmeida

rpalmeida · 11-01-2024

Hi.Is there any way to do route leaking VRF<->GRT and GRT<->VRF with BGP or MBP?I usually do with a cable in 2 ports in same switch or the traditional way, with Tunnels and IGP ( like ISIS, or OSPF or EIGRP ).In attachment i send an example of my tra...

rpalmeida · 08-20-2024

Hello,Can anyone help me, when i implement one config or the other config.Send the 2xConfigs in 2 attachments.Thanks.Best Regards.

rpalmeida · 08-20-2024

Hello,To implement MPLS L2VPN (transport Vlan 100 from one PE to another PE), either by BGP SIGNALING or by LDP SIGNALING on a Native IOS or IOS-XE, which of these scenarios could be the simplest ( 2 print files in attachment )?It is advisable or cus...

rpalmeida · 02-26-2024

Hello. I have to implement a scenario similar to or the same as what I am trying in the picture that I send as an attachment. I have 2xCE and I have 2xPE. From 1 CE, i can ping the 2 multicast groups (239.0.0.2 and 239.0.0.4) From the other CE i c...

rpalmeida · 11-12-2023

Hello,I'm normally doing vrf leaking between GRT and VRF and VRF and GRT with 2 tunnels inside the same switch (6500).I make a tunnel with GRT and another tunnel with VRF and then 2 OSPFs or ISIS with BGP and everything works perfectly.Is there any o...

rpalmeida · 11-03-2024

Hi MHM,I tried with Catalyst 6506 and 6506 with IOS v.12 and that command ( export ipv4 ), isnt avaible.Well i will try to go around this.

rpalmeida · 11-03-2024

Hi,With that info, you solve some issues i had.Very gratefull.Best regards.

rpalmeida · 11-02-2024

MHM.I just tried with Cisco Catalyst 3560G-48 and when i do "vrf definition" i receive a information that says:Switch(config)#vrf definition A% Command accepted but obsolete, unreleased or unsupported; see documentation.I will try in Cisco Catalyst ...

rpalmeida · 11-02-2024

Hi MHM, I dont have the command "export ipv4 unicast map" in GNS3, with the image of 7200, to test the config before i implement it.I have only the "import ipv4 unicast map", under VRF.Best Regards MHM.

rpalmeida · 08-20-2024

Hello Harold."If you are already running LDP in the core to signal the LSP between the PEs, it makes sense to use LDP for the VPLS signalling as well.If you use some other protocol (RSVP or SR) to signal the LSP then it would make more sense to use B...

Member Since	‎03-04-2018 02:55 PM
Date Last Visited	‎11-08-2024 03:37 PM
Posts	28
Total Helpful Votes Received	5

User Statistics

User Activity

VRF to GRT with BGP

L2VPN Configs

VPLS BGP Discovery & Signalling

MPLS Multicast 1CE can ping both Multicast, other CE can ping only 1

VRF LEAKING IN SAME SWITCH ( Cisco 6500 ).

Re: VRF to GRT with BGP

Re: Hi Bob,

Re: VRF to GRT with BGP

Re: VRF to GRT with BGP

Re: VPLS BGP Discovery & Signalling