Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After a few years doing this, the biggest thing I'd tell anyone starting out isn't which tool to pick. It's to resist pushing config for as long as you can.Almost every early win is read-only anyway. Pulling show output, backing up configs, checking ...
Hi @uni1389 ,The clearest issue is that the cEdge has no certificate installed: local-properties shows certificate-status Not-Installed and serial-num "No certificate installed", and a cEdge only forms the vSmart (OMP) connection once its cert is in ...
Hi @Network Digger ,The C8300 has a single route processor (no dual-RP chassis), so classic intra-chassis NSF/SSO, which needs two RPs or supervisors, does not apply to it.For keeping sessions stateful across a failover, the platform uses Inter-Chass...
Hi mdieng,The asymmetry is expected. Outbound most likely works because the loopback is source-NAT'd out the transport (DIA), so replies return on that session. Inbound to the loopback's own public IP is a separate path that configuring the loopback ...
Hi jeepoy,First and most important, this is the Cisco/OpenDNS community forum, not OpenDNS support, so posting your IPs here will not get them whitelisted. Open a ticket with OpenDNS support directly and give them your current public IP(s) plus the S...
Hi @wz164 ,That error is on OpenDNS's side, not your setup. Your static IP sits inside a larger block that another OpenDNS member has already registered and marked CLOSED, and a CLOSED network blocks any other account from registering IPs within its ...
