Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure an IPS sensor for the first time and need to configure an IP address. I am confused about what IP address to use. I am probably over thinking this, but does the sensor get an IP address in the same range as the GI0/1 IP add...
I have two 2801 routers with cme. The VOIP dial peers can call another dial peer in the system, remote and local. The routers also have 2 port fxs cards. An Analog phone plugged into the fxs card with analog dial peers can dial other analog dial p...
This may be really unusal, but its real. I want to have a remote router (1712) have two tunnels to two separate VPN Hubs. On the remote I have two tunnel interfaces, using two different interfaces, 1 Physical and 1 Virtual (Vlan1) I would like to ...
I am installing a 4.1 Call Manager server in my lab prior to going live and I can get third party softphones to register, but can't get the Cisco Softphone to reqister. I have the latest softphone available on the Web site.
There will be some traffic from hub 1 to hub2 via the remote, but mostly I need the remote to be able to access hosts at 2 different sites at the same time, and the two hub sites won't be able to communicate with each other unless the remote is acti...
unfortunately no, we didn't solve this issue. we ran into bigger issues and had to change to the 1712 routers to solve those and the IPSEC/GRE tunnel on them does come up on its on.
