Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,is it possible and recommended to connect a active/passive firewall (Cisco Firepower) with a L3Out to Cisco ACI without SVI? Instead of SVI we want to use routed port because we need multicast support on this L3Out. Multicast over SVI is not s...
Hello Community, I have a ASA with a local VPN Pool where the VPN users get their IP-address. Is it possible to advertise this network in the bgp process? Thanks and regards,Philipp
Hello Community,I´m not able to register my ASA with Firepower at the FMC after I deleted the device. Following error message at the FMC: FMC: pigtail | grep -IP MSGS: 12-18 09:32:42 ifs-fire-v1 SF-IMS[5083]: [5083] sfmgr:sfmanager [INFO] set peer PE...
Dear all,
is it possible to permit specific apple-tv airplay services per accesspoint? So that in a meeting room I only see the local installed apple-tv and not all apple-tv´s in the company? We don´t have a WLC yet. It´s only a question if this setu...
Hello Community,
is it possible to customize the URL of a Guestportal located on ISE (2.1)?
Current URL is: https://IP/NAME:8443/portal/PortalSetup.action?portal=2c050b70-e1d2-11e8-b03e-1c6a7ac127a6
I would change the URL to something like this...
Hello Marvin, yes. I already tried to delete and add the manager without success. But meanwhile i solved the problem. I made manually an update of the Firepower instance of the ASA. After that i was able to register the device in the FMC again. I fo...
Hi Anthonylofreso ,thanks for the fast reply. Unfortunately we don´t use the Guest Portal on ISE for this authentication. Were just checking if the credential are correct and grand then access to the wifi (ISE is only RADIUS Server for the wifi locat...
Hi Paul,thanks for the detailed information. But I think that our phones do not support EAP Proxy Logoff.... Yes, the PCs behind the phones doing 802.1x. So we have to look for the inactivity timer. Again thank you very much for the support!
For ...
