ASA5525-X# show run | include access-list inside_nat0_outbound access-list inside_nat0_outbound extended permit ip host 10.128.1.2 host 10.128.5.1 access-list inside_nat0_outbound extended permit ip host 192.168.10.3 any access-list inside_nat0_outbound extended permit ip host 10.0.2.78 any access-list inside_nat0_outbound extended permit ip host 192.168.10.4 any access-list inside_nat0_outbound extended permit ip host 10.0.2.79 any access-list inside_nat0_outbound extended permit ip host 10.0.2.77 any ASA5525-X# show run | include access-list DMZ_nat0_outbound access-list DMZ_nat0_outbound extended permit ip host 10.128.5.1 host 10.128.1.2 ASA5525-X# ... View more

@balaji.bandi look screen shot i will add manual ipv4 but when i >show interface ip brief they show no ip in management port look screen show what happened what is problem... I just deployed a FTDV VM on a vSphere host. I assigned a static IP during the OVF deployment, and running   show network   from the CLI shows the IP address I assigned to it. Yet   show interface ip brief   does not, nor am I able to ping the assigned router, and looking at the running-config it has   no ip address   for the management0/0 interface. The CLI is dissimilar enough from IOS/ASA that I can't seem to figure out what I need to do to assign an IP as   configure terminal   doesnt exist and   configure ?doesnt seem to have anything relevant beyond   configure network ipv4 manual   which will just change what shows up in   show network   but not in the actual running-config. I've read the Quick Start guide and I dont think I skipped any steps. Does anyone know what I did wrong, and what you need to do to assign a IP to the management interface?   ... View more

@balaji.bandi both are same subnet    FMC ip 192.168.2.198 255.255.255.0 Gateway 192.168.2.1 FTD ip 192.168.2.197 255.255.255.0 Gateway   192.168.2.1 FMC working Fine its Ping able and acces gui web But  FTD not working i well post snapshot what problem is  ?   ... View more

Rahul Govindan   i configure the ip on ftd but i cant access ftd gui and also i cant ping able to the ftd 6.2.3 please help me what the problem is    Rahul Govindan Member since 10-28-2015     VIP Advocate           See all badges   1420   1455   313 Send MessageView Profile   ... View more

IF you Are you using VMware OR vShere you can following configuration on your hyperviser   You need 100 gb hard disk 6 gb ram  Select a Guest operating system Linux Version Red Hat Enterprise Linux 5 64-bit         ... View more