Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 4402 WLC configured on the management VLAN and 9 AP's that were converted to LWAPP. When the AP's attempt to connect to the WLC, they download the image then display the following error. "No more AP manager IP addresses remain." The AP's t...
I am trying to convert Airnet 1220 AP's from thick to thin so I can use a 4400 WLAN controller. I've upgraded the AP's to the latest firmware release. When I use the upgrade tool I receive the following error in the error log.2008/10/08 21:27:40 IN...
Is it possible to set up a VPN with the same subnet at both ends? For example, router 1 FA0/0 interface IP address 10.1.1.10 255.255.255.0, serial interface 192.168.100.1 255.255.255.0. Router 2 FA0/0 interface 10.1.1.20 255.255.255.0, serial inter...
I inherited a wireless network with multiple wireless AP's connected to two GW's in a mesh configuration. The GW's are wireless AP's as well and are connected to two separate 2950 switches. Each switch is connected to 2621 routers.The AP's hand out...
Thank you. It was a duplicate IP address. *sigh*One of the reasons for this error message is when there is a duplicate IP address on the network that matches the AP manager IP address. In such a case, the LAP keeps power cycling and cannot join the...
I tried both suggestions without success. The same thing continues to happen. Looking at the logs, I see that APs are associating then immediately disassociating. If it helps here are 15 minutes or so of message logs from the WLC.Jun 04 09:11:04.9...
Don't have those. Does anybody else have any suggestions?This whole exercise is an attempt to manage routers across a serial link from a single point of contact. Both sides of the link are on a 10.1.1.x network because of a wireless mesh configurat...
