Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear readers,
I am running into an issue, we are replacing a draytek router model 2130 with a Cisco 4331 router.
The internal network is working fine but I cant seem to get the internet working.
I tried searching the forums and looked up multiple Cis...
Well the throughput is the issue
If I understand correctly from the cisco page it should be the command
platform hardware throughput level 300000
Assuming the license you have supports that, if that doesnt work you might have to activate/register the...
can you try the following command?
sh platform hardware throughput level
This should give the current throughput level
The command
show license feature
Should give a good overview of all licenses
The specifications also mention that the base throughput is 100 for the Cisco 4331.
You can upgrade it with a license up to 300.
For more on the specifications please see
https://www.cisco.com/c/en/us/products/collateral/routers/4000-series-integrate...
Thank you all so much for the help,
I added "ip route 0.0.0.0 0.0.0.0 5.83.2.161"
also removed the "spanning-tree portfast trunk" on port g0/0/0.
The webinterface wont let me do the WAN test anymore because it keeps saying there is no port configured...
Dont worry I am still here, sadly I am stuck on very short time frames because the employees require internet access.
setting alarm extra early to test all the help just posted.
internet access is the primary target, all other things are on hold. (Pr...
