Cisco Community
English
Register
Change to content subject titles: starting July 28 there is a limit on the number of characters to use - LEARN MORE HERE
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
amikat
‎02-28-2021

Rising star
Recent Badges
Awards
Recent Badges
See all
300 Helpful Vote
100 Helpful Vote
50 Accepted Solution
15 Accepted Solution
1 Accepted Solution
5 Accepted Solution
30 Helpful Vote
10 Helpful Vote
1 Helpful Vote
50 Replies
Stats
Member since ‎08-11-2000
576
Posts
482
Helpful
86
Solutions

Re: 93180 Management Port Configuration

Created by in Network Management
02-25-2021
02-25-2021
Hi,Please note that the management port (mgmt0 interface) is assigned to the management vrf by defau...

Re: Cisco 6500 not logging ACL denies but does log other things.

Created by in Network Management
02-23-2021
02-23-2021
Hi,Thanks for the feedback. My final comment is this: due to the ACL logging you may experience high...

Re: Cisco 6500 not logging ACL denies but does log other things.

Created by in Network Management
02-22-2021
02-22-2021
Hi,The access list log messages are severity level 6 (informational) so to get these on the syslog s...

Re: Cisco WS-C2960-48PST-L , 802.3af

Created by in Switching
02-16-2021
02-16-2021
Hi,Polycom VVX201 is a IEEE 802.3af Class 2 device and as such you can connect this IP Phone to all ...

Re: cisco switch can ping svi and one host but not another on same vlan

Created by in Switching
02-14-2021
02-14-2021
Hi,You would need to configure the gateway & static route at your pfSense box to reach the Vlan 1 ne...

Re: Unable to remove sub interface and interfaces don't match across Primary ASA and failover

Created by in Other Network Architecture Subjects
02-13-2021
02-13-2021
Hi,You may be hitting the CSCvo58030 bug - please check. The suggested workaround listed with the bu...

Re: VTP Issue

Created by in Switching
02-10-2021
02-10-2021
Hi,Routers do not forward vtp packets unless they are configured as bridges or contain switching mod...

Re: This switch can support dot1x?

Created by in Switching
02-09-2021
02-09-2021
Hi,Thanks for the feedback. Please make sure your switch port is configured as access (switchport mo...

Re: This switch can support dot1x?

Created by in Switching
02-09-2021
02-09-2021
Hi,The "authentication event" command was introduced at the 12.2(50)SE IOS release. Starting this re...

Re: Port Based Address Allocation DHCP not Assigning Addresses

Created by in Switching
02-07-2021
02-07-2021
Hi,Thanks for the reply. I have checked the configuration in my lab and my box keeps the commands as...

Re: DHCP not working on SG200-26P

Created by in Switching
02-07-2021
02-07-2021
Hi,Which is the SW03 port your device is connected to? Can you please configure that port as "Trunk ...

Re: Port Based Address Allocation DHCP not Assigning Addresses

Created by in Switching
02-07-2021
02-07-2021
Hi,In my view the interface short name is case sensitive. Can you please try to adjust your pool con...

Re: Cisco 2960 trunk configuration

Created by in Switching
02-06-2021
02-06-2021
Hi,You do not need to create "interface vlan x" but you should create vlans instead, ie:vlan 10exitv...

Re: WS-X6708-10GE - Module 13 installation makes this system non-NEBS compliant

Created by in Switching
01-03-2021
01-03-2021
Hi,Yes provided you have OIR inserted the module when the system was already running the reboot with...

Re: WS-X6708-10GE - Module 13 installation makes this system non-NEBS compliant

Created by in Switching
01-03-2021
01-03-2021
Hi,You are using different versions of the PFC3x and DFC3x boards namely PFC3BXL with SUP720 and DFC...
Public Statistics
Date Registered ‎08-11-2000 01:23 AM
Date Last Visited ‎02-28-2021 01:51 PM
Total Messages Posted 576
Total Helpful Votes Received 482
Helpful Votes From