Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
We have an IR1101 with a 5G modem. In logging we can see that it is constantly flapping between 4G and 5G and we want to lock it on 4G.We searched all documentation and tried all posibilities but nothing seems to work. Below some details.
Log...
Hi all,
After upgrading from ir800-universalk9-mz.SPA.158-3.M4 to ir800-universalk9-mz.SPA.159-3.M9, each time I reload the router it gets stuck in rommon. When I do a powercycle it always boots normally.
Below is the message I see.
mount: /dev/fla...
Hi all,
I am testing an EEM script that shut / no shut an interface if a track is not UP (name of the script reset-cellular).The EEM script worked, now I wanted to implement the EEM script into another EEM script (name of the script is test).
Now if ...
Hi all,
I am looking for a solution (EEM applet, ...) that as long as a tracker remains down the router will reboot every 15 minutes.Now the router reboots when the tracker is down (using EEM applet) but if after the reboot the tracker stays down the...
Hi all,
We have a Cisco 892 and we are experiencing some performance issues.When testing using Iperf from LAN to WAN with speeds of 750Mbit/sec (packet size 1024K) we see packet loss when pinging the LAN ip address (Vlan 100) of the router.I was told...
Hi,
I already saw that thread but the author choses to use 5G also since the Radio Access Technology(RAT) Preference is set to AUTO.With my situation 4G has a good coverage.
LTE Bandwidth = 15 MHz
Current RSSI = -46 dBm
Current RSRP = -77 dBm
Current...
I already tried that but it doesn't accept the command.
Router(config-controller)#lte modem band-select indices umts3g none lte4g all slot 0
Incomplete config: nr5g indices need to be specified also for this modem type.
Kind Regards
Hi,
Thank you for the reply and I red the bugreport. But this is only when it's on 4G. For me is the swap between 4G and 5G an issue.
Jul 18 05:03:55.251: %CELLWAN-2-NC_EVENT1: Cellular0/1/0: Network change event - fallback from ENDC to LTE.
Jul 18 0...
Hi BB,
Thank you for your feedback. Can you explain to me that if we do a power cycle of the router we never have this issue, only when we restart the router using the reload command?
I would understand your explanation if the Flash seemed corrupt an...
Hi Dan,
Thank you for the solution!
Also a quick note, I had to adapt action 009 in the same way. See code below.
action 009 cli command "action 030 regexp $q Reachability is ([\_A-Za-z0-9]+) $q $q \$_cli_result$q match state"
Best Regards!
