Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have two mellanox switches connected to Cisco L3 switch stack using two 10gig interfaces. On cisco two ten gig links are configured as port-channel trunk at L2 and on Mellanox 10gig interface from each switch is connected to Cisco is set on ML...
Hi,
I have two MLNX switches in MLAG configuration and one interface from each MLNX switches is connected to cisco L3 switch in mlag-port channel with two ten gig ports in trunk. My question is how to configure ospf configuration between MLNX switche...
Hi Georg,
Thank you for you reply. As auto-cost reference-bandwidth command needs setting on all routers, this would mean I need to set this on routers connected, but I have other routers connected to Cisco L3 switch that are out of my administrative...
Hi,
I can reach 192.168.2.0/24 network (vlan 2). I want to make sure this is correct and supported or any other better solution, but still maintaining high availability between Cisco L3 switcth and Mellanox?
Physical and logical diagrams are includ...
