About odeynitus

odeynitus · 10-18-2018

I haven't had to configure an AP to broadcast a SSID before. But I was asked to configure an SSID on one of our location's AP. I have the SSID broadcasting, but when I connect devices to it, all the devices don't get an IP that is in our DHCP scope...

odeynitus · 10-19-2018

Awesome! It is working now! I changed the switch port to trunk as you suggested and also suggested by patoberli. Thank you folks!

odeynitus · 10-19-2018

The AP connects to int gi2/0/4. I did as you said and modified vendor1 ssid. dot11 ssid vendor1 vlan 21 authentication open authentication key-management wpa version 2 mbssid guest-mode dtim-period 2 wpa-psk ascii 7 052A0F1D0543411B4E56end

odeynitus · 10-19-2018

This ap wasn't really managed at all. It was recently that I was asked to start managing it. I will be sure to utilize the radio1 interface for the better performance. I added "mbssid" to the radio0 interface and I am not getting an IP address sti...

odeynitus · 10-19-2018

Yes I should have them defined. I attached both the AP and Switch config. I checked and the SSID (Vendor1) that is vlan 21 is the SSID I am troubleshooting. The SSID (Secure) that sits on vlan 11 is the working SSID. In regards to do you think...

Member Since	‎04-02-2018 09:53 AM
Date Last Visited	‎10-07-2024 02:56 PM
Posts	5

User Statistics

User Activity

New SSID doesn't assign DHCP addresses to devices, Cisco Aironet 3600 AP

Re: New SSID doesn't assign DHCP addresses to devices, Cisco Aironet 3600 AP

Re: New SSID doesn't assign DHCP addresses to devices, Cisco Aironet 3600 AP

Re: New SSID doesn't assign DHCP addresses to devices, Cisco Aironet 3600 AP

Re: New SSID doesn't assign DHCP addresses to devices, Cisco Aironet 3600 AP