Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
What are the troubleshooting steps to troubleshoot a multicast issue?
My host is both a source and receiver to a multicast group. While I am able to send data out (verified by looking at other hosts outside of my network) I cannot receive.
What a...
Hi,I have a ASA 5525 that connects to two networks - eg 10.10.10.0/24 and 11.11.11.0/24. Due to a requirement I need to configure port 0/0 for one-way out going traffic and 0/1 for one-way incoming traffic.My ASA ports will interface a BAE's data-dio...
Hi,I have a 3750 and a 4500 that are trunked together to share vlan 10 and vlan 100 through a VTP domain - test. The VLAN 100 on my 4500 has an IP of 192.168.3.1 and the VLAN 100 on my 3750 has an IP of 192.168.3.5. Is this do-able? For some reason I...
Hi Jon,I only have one vlan in a small network and it is vlan 100. The reason I have 4500 and a 3750 is because I have some workstations and servers that are connected at 10Gb speed to the 4500, but both switches are on the same VTP domain.I need all...
Can I have the default route for both 4500 and 3750 all point to the IP address of the firewall's inside interface?I just have one vlan 100 on both switches that need to go out through the firewall. The firewall inside interface can be connected to e...
Hi Jon,It is an ASA5525 and it does have a route back to 192.168.3.0/24. Is it okay to have an IP for vlan 100 on both 4500 (192.168.3.1) and 3750 (192.168.3.5) under the same VTP domain?It troubles me when I can't ping my vlan 100 (192.168.3.5) and ...
