Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to adjust the TX power on my access points so clients get connected to the closes AP when they move and do not get stuck to a single one. I adjusted the TX power using a RF Profile between 8 - 14 dBm, but after a while I still see some of ...
I'm trying to adjust the TX power on my access points so clients get connected to the closes AP when they move and do not get stuck to a single one. I adjusted the TX power using a RF Profile between 8 - 14 dBm, but after a while I still see some of ...
Hi, thank you all for your replies,I just want to understand why power on my APs goes above the configured range. I understand that most of the replies are focus on roaming and that sort of things. The clients in the network are POS handheld terminal...
Thank you all for your replies...My question is related to the fact that after I configure my profiles to deliver the AutoPower max and AutoPower min to the values I want, the access point stills uses more power than the configured value even when it...
