Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In configuring FTD cluster mode, 2 4115 appliances have channel-group 48 configured and both FTD's are connected to a 9400 with a channel-group 48. I can get only 1 interface in the ether channel up at a time. One is always in a suspended state.FX...
1). I am migrating ASA with 7 contexts to FTD. Attached is the 4115 Chassis Manager Interface screen. I would like multiple instances to share the same port channel with different VLANS. Once I associate an Instance with a portchannel, that interf...
How do I configure an IOS-XE switch for SpannedEt andhernet for FXOS 2.10 and FTD 7.0? My CCL interface on the 4115 appliance remains failed and down. The 4115 has an amber light for the assigned CCL. The Portchannel 48 with a member interface eth1...
According to this document regarding Clustering: Deploying a Cluster for Firepower Threat Defense on the Firepower 4100/9300 - CiscoDeploying a Cluster for Firepower Threat Defense on the Firepower 4100/9300 - CiscoWhen you deploy a cluster on the Fi...
Okay creating the port channel and subinterface on Firepower Chassis manager works only when I create an instance that is STANDALONE. When I create a CLUSTERED instance all of those same port-channels and subinterafaces are missing.
I'm confused, in this post you say to assign subinterfaces in FMC but above you are saying to configure subinterfaces in Firepower Chassis manager. https://community.cisco.com/t5/network-security/vlan-sub-interface-unassignable-during-ftd-container-c...