Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having this weird behavior which i hope someone can provide good pointers.My primary controller is stuck in maintenance mode. Switchover reason on the current active(Secondary unit) is Default gateway is not reachable. This happened on Thu Feb 2...
Hi TeamI have my primary WLC 5520 (software 8.10.105.0) stuck in MAINTENANCE. I have remotely tried reset system with out any success.The software version is the same as standby HA. I can ping the RM and RP ip address from both Primary to standby a...
Hello good people. I have recently bought Cisco AIR CAP3502I E K9 but i am seeing that it can only work with WLAN controller. How can I make it work as a stand alone.Your help will be appreciated.
Well i also did remove the cables a reset from CLI. It remained stuckc in maintenance. I guess its a bug.I will feedback once cisco provides a conclusive investigation.
Thanks Scott For my case, switching power OFF/ON did the magic. I am raising a TAC so we know if there is a known solution for this issue now. You also suggested removing all cables and rebooting the WLC. I realized that this option will correctly t...
Thanks i will try this tomorrow.From reboot history see below some informative logs i got. ========================================Reset reason : active default gateway is not reachable ,(Version: 8.10.105.0)Reset time : Thu Feb 20 15:40:38 2020Tra...
Got the autonomous IOS running now.last issues is how do i enbale POe.The deployment place has no power but the network cable has been laid to the place.its running 1260 IOS
