Hi at all I have a router (R0) cisco connect with one interface e0 to network 192.168.2.0/25 (inside) and one interface e1 to network 200.10.20.0/24 (outside). On the inside network there are many host that receive the ip and def-router from dhcp server on R0. The host of network 192.168.2.0/24 comunicate with host in network 201.10.21.0/24 trought the ip of e1 interface on router R0 whit nat, this work fine and test with ping. The of the nat in router R0 is the following: Interface fastethernet 0 ip address 192.168.2.1 255.255.255.0 ip nat inside Interface fastethernet 1 ip address 201.10.21.1 255.255.255.0 ip nat outside ip nat pool over 201.10.21.1 201.10.21.1 prefix-length 24 ip nat inside source list 101 pool over overload access-list 101 permit icmp 192.168.2.0 0.0.0.255 201.10.21.0 0.0.0.255 access-list 101 permit ip 192.168.2.0 0.0.0.255 201.10.21.0 0.0.0.255 Now i need to configure R0 so as redirect all traffic of the hosts in inside network to internet to proxy server 201.10.21.200 on port 8080. I have fount difficult to accomplished this task using nat. What is the best solution for this task?? Tanks for any response ... View more

Hello, I have a big problem, I don't know what is possible configure the ap for two distinct subnet one for wired LAN an one for Wireless LAN. ... View more

Hi all, I'm a little confused, I have a some questions: I have several aironet 1141 device all connected to the wired LAN. Can I configure all AP so that create a single network wireless? Can I configure all AP like DHCP server with same ip pool? Thaks all for any answer ... View more