Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have 7 access points running on WLC 2504 and trying to add another one for a total of 8 APs Sysinfo shows I am allowed up to 75 access points, license is showing I have 7 AP in use of 7 available but have another license for 5 not in use.Wha...
Hello,I have a stack of 6x 3850 PoE capable switches, recently some ports started to fail to give PoE and/or going up/down where PoE devices are connected to, like Cisco Access Points, Digium desk phones, other PoE devices.I have:1) changed cabling2)...
Good evening all,
I have an issue with properly configuring VLAN tagging so being able to connect a computer to DATA VLAN from an non-cisco IP phone.
Goal is to have an IP phone connected to VOICE vlan and get DATA vlan to a host from it.
In th...
(Cisco Controller) >show udi NAME: "Chassis" , DESCR: "Cisco 2500 Series Wireless LAN Controller"PID: AIR-CT2504-K9, VID: V06, SN: PSZ20101HQ5 I was hoping to be able to use the additional 5 licences or add one more to the existing 7 Otherwise,...
Sorry while I appreciate your help I still believe this is not a cabling issue.I have plugged a PoE VoIP phone directly to the switch1 int gig 1/0/7 with new LAN cable and got this output Apr 4 15:08:44: %ILPOWER-5-IEEE_DISCONNECT: Interface Gi1/0/7...
Did an upgrade to cat3k_caa-universalk9.16.03.07.SPA.bin Now all PoE requiring ports are marked as faulty on Switch1,I've tried to cycle them with shut/no shut with a non PoE device connected to it but goes bad as soon as you re-plug PoE deviceIn fac...
