Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Does N93180YC-EX support FEC in 25G ports with 5m DAC cables with NX-OS? Cisco optics matrix link shows that this is supported for 3m cable, but no information available for 5m cables. Does this mean N93180YC-EX does not have support for 5m DAC ...
Hi,
I am trying to configure profiling using Cisco ISE 2.4 to find out the devices connected to my switch interfaces before configuring them for 802.1x authentication.
Cisco ISE profiling has lots of probes listed, but my query is :
1. Is it po...
Hi,
We are planning to deploy ISE for 802.1x authentication for wired LAN. We want to authenticate the AD users who are logging in through domain PCs to gain access to network based on 802.1x.
Please help me with the following scenario.
1. User...
Hi,
In our data center network, there is a requirement for having hybrid overlays as there is a mix of vmware NSX-v and physical work loads. There is a scenario in which hosts in the same subnet are spread across the physical and virtual environme...
Hi, We are planning to deploy Cisco ISE in our environment for both 802.1X authentication and Tacacs+ for Network device administration. Is there an option to configure Tacacs+ logs being sent from PSN to external log servers other than MnT node?
Hi,
Thanks for your response. I would like to try the windows native supplicant and i am fine with the authentication in succession - machine authentication during bootup & user authentication later. Could you please let me know if there are any gu...
Another question - I am trying to authenticate a corporate user with a corporate device to gain access to the network. The corporate device has two certificates – one for the machine, another for the user. I want to match the hostname of the computer...
Hi,
Thanks a lot for your response. I have responded to your queries. The NSX in my environment is getting restricted to Leaf1 & Leaf2 which i had shown in my diagram. My physical server is not connected to leaf2 and so it does not have layer2 adja...
Hi, To make myself very sure, Is the below mentioned diagram a valid design for positioning the ISE components? I am planning to position two PSNs one in each data cener. In case, the local PSN fails, the endpoints need to authenticate with the other...
