Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to connect to a windows xp machine connected with Cisco VPN client, by unsing a tools named VNC or pcAnywhere.By defaut the client reject the incoming connections. What can I do on the Cisco VPN client to accept incoming connections ?RegardsFe...
HiI just upgrad my Pix from IOS 6.3(4) to 7.0(6). After that my Cisco VPN client cannot make a DNS resolution. The ASDM syslog message display the following message "Deny inbound UDP from 10.200.200.1/137 (138) to 10.255.255.255/137 (138) on interfac...
After changing the IP address of the TFTP server in my Pix config, the config backup on the TFTP server failed.The error message displayed while trying to backup the running config via PDM is the following attached.Help pleaseRegards
HiSince I changed my TFTP server IPaddress on my pix 515E, I get error when I try to save my config. The Pix displays the following error : "Timed out attempting to connect [FAILED]"I need help pleaseRegardFerdinand
I would like to block all instant messaging applications trafic on my pix 515. Some of them use socks protocol. Can someone help me to block these applications or this socks protocol on my pix 515 ?Regards
Thank you acomiskeyI have disable the stateful firewall on the cisco vpn client, but I always have "connection rejected" when I try to connect.One question please : once my vpn client connected, it not get the LAN default gateway and the good netmask...
Hi PatrickThere are a route to the 10.x.x.x network, and the ping TFTP server from the Pix works alsoorion# ping 10.75.3.13 10.75.3.13 response received -- 0ms 10.75.3.13 response received -- 0ms 10.75.3.13 response received -- 0...
Hi PatrickThank you very much. It is good now.I have three small questions please 1- I don't know how tu use "netstat" command to see what servers messenger is connecting to.2- How I can see the statistics about my "acl-inside"3- After changing my TF...
ThanksI have not put an explicit permit. I will do it tomorrow and will inform you.However when I apply the ACL on the inside interface going out, I have error. But when I apply it on the inside interface going in, I have no error. Can you tell me wh...
