Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiThe MX has 2 Uplink WAN interfaces and some models like MX67C 1 LTE Uplink.Can I use both WAN links + LTE?If I Use 1 WAN Link and a LTE link, it's possible to balance or apply traffic policies in both links?Regards
HiI have some design questions regarding MX on DCI see that performance is about clients and VPN throughput. But there is any info about the maximum number of VPN tunnels?If I have in a DC 2 MX :The only way to configure both devices to concentrate ...
Hi It is possible to configure the same network for Service Side NAT pool but in different VPN/VRF? Ex:VPN 1Inside Local : 10.0.100.0/24Inside Global : 192.168.100.0/24 VPN 2Inside Local : 10.0.101.0/24Inside Global : 192.168.100.0/24 Thanks!
HiI have an IR1101 router with Cellular interface(Cellular0/1/0).This interface has a /32 ip address. I need to configure an ip route via this interface but it is not possible with VPN template that only allows next hop. I'm trying with a CLI ADD-ON...
Thanks.In a product update session it was announced that the buil-in LTE will be used as normal WAN link not only for failover.But I don't know if with this upgrade the MX will use 2 Ethernet WAN + 1 LTE WAN LinkRegards
In Cisco-Viptela SD-WAN, VPN is the same as VRF What I mean is, in the LAN side I have : VPN 1 (= VRF 1)with 10.0.100.0/24 network . This network is translated (Service Side NAT) to 192.168.100.0/24VPN 2 (= VRF 2)with 10.0.101.0/24 network . This n...
HiThanksI'll keep both solutions, self ip address next-hop and cli add-on.Because in some cases the IP address could changeDo you have a link to a CLI add-on configuration guide ?
