Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys, Does anyone knows how long should an overlay fabric be up and running when it loses one of the controllers, for example:vBond - How long can it be downI know that if it is down, new routers or routers that we're down aren't able to join.vSm...
Hi Guys, Any of you had any experience using AMP with the SD-WAN Solution? I've recently been entitled with a Threat Grid Account and since then I'm not able to configure any device that has the security policy with AMP configured. The error I'm gett...
Hi guys,
Recently I've posted a thread asking how to attach interfaces to A-VPLS, tested it today and it worked perfectly as stated here.
Now we're trying to mesh the A-VPLS with a regular VPLS on an ASR1001. It's seems it's not as it was suppos...
Hi guys,
I'm about to deploy A-VPLS and it's the first time. I've working with VPLS (traditional Configuration) and with the A-VPLS configuration I'm getting a bit confused.
Let's say I have this configuration (same as config guide)
pseudowire-c...
Hi all,
Does anyone know any alternative to port-security or dot1x to secure interfaces.
We're trying to secure interfaces connected to 1850 Access Points, but the catch is that we're using LACP, so port-security and 802.1x isn't supported.
The a...
Hi Please read this post below which has the information that you want. https://community.cisco.com/t5/sd-wan/ipsec-interface-not-available-from-vpn0/m-p/3928722
Hi Olivier, As far as I'm aware you can only configure DNS Servers for the customers to query, or dns-redirect for bypassing umbrella for example.Setting the router as dns server as you usually do on regular IOS routers, I don't think that's possibl...
Hi, One thing you could do is this:vpn xx ip route {dns_ip_address/32} vpn 0 Or you could do a taffic data policy that matches UDP 53 and set nat-vpn 0 on that policy. Best Regards,
Hi Juraj, Is your vManage configured to sign the Cloud Edges automatically? If that's the case what you'll need to do is having them on the device menu tab, and once they're there you'll be able to retrieve their token and chassis-id.After that jus...
