Does anyone know if it possible to use the UTLite component of User Tracking to send the users details to two separate Ciscoworks servers without running UTLite twice?
Gday Doyne,I'm not 100% sure what you are trtying to achieve but I think your simplest solution would be to run three vlans/ip subnets in your network.OfficeA VLAN --> Inter-Router VLAN <-- OfficeB VLANYou would need to set some ip routes to pass tra...
G'day Josh,Not sure if it's quite what you are looking for but checkout the CISCO-SAA-APM MIB.Should be able to download it from the Cisco site if you can't find it let me know and I can send it to you.HTH.Dan.
SNMP trap for up/down have been enabled on the port.For any ports you do or do not want to get snmp messages for when they change state use one of the following:'set port trap enable' to get trapsand'set port trap disable' to not get traps.
Check out:.1.3.6.1.4.1.9.5.1.4.1.1.10.. for the duplex setting for a port.Integer Values can be:1 half2 full3 disagree (when the port was auto and it can't agree with host)4 auto.1.3.6.1.4.1.9.5.1.4.1.1.9.. for the 'desired' speed of the port.Integer...