Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is below possible in the DFM High Severity Alerts box:1. When an alert is acknowledged the ICON must change to (for instance) yellow (indicating that the alarm is being taken care of)?2. Change the default severity to other levels than critical or in...
Hi Forum -Using CSM modules running 3.1.4 in a GSLB setup with ressources in two data centers - east/west - I would like to achieve load balancing between the two data centers (3 servers per location running same application) based on the source IP o...
Hi -Following the sw upgrade procedure from FWSM Configuration Guide (reload standby->switch active->reload primary->switch back) I had no problems upgrading with zero-downtime from 3.1.3 to 3.1.4in active/standby failover pair. Making the exact same...
Hi -Anybody experienced something like this (suppse it a bug of some kind):After having defined reals I add them to serverfarm, but in configuration they appear twice - ex.: serverfarm TRIWEBPROD nat server no nat client predictor leastconns real...
Hi -When using leastloaded in GSLB setup a probe is needed to get load data from remote CSM. Is it possible to initiate probes from specific interface on CSM?Does the secondary unit in a ft setup make own probes, or is it updated on the load from the...
The local address in the static command does not have to be on the directly connected subnet. So nothing is wrong about the command. Off course routing to support the setup has to be in place.Pls post the config, and log for further investigation.Bes...
Hi alan -If you do routing in the switch between different vlans and IP nets you can apply an access-list to the L3 interface - but then of course you introduce a L3 hop, and will have problems with the placement of the DG.
Connect pc1 to vlan 10 interface in switch, and rtr2 to vlan 20 interface in switch. Connect rtr1 to switch and configure dot1q trunk between switch and rtr1 allowing vlan 10 and?20. Configure bridging between vlan 10 and vlan 20 subinterface on rout...
Hi -Can you provide a sh interface trunk from the Cisco device. The Native VLAN concept is a part of the 802.1Q standard, and must be identical in both ends of trunk (according to Cisco to prevent Spanning Tree loops).
How are you trying to accomplish this?The PIX cannot act as a tftp server - only as a client. If you are trying to get the configuration from the tftp server to which you backed it up it looks like a connectivity problem. Is it possible for you to pi...
