Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have setup a VPN between and ASA5505 and a PIX 501. It seems as though the VPN is "on demand" meaning if I don't use the connection to the far end private network, the connection dies and is restarted when I try to initiate connectivity back to the...
My upstream provider is changing IP blocks. They are presenting both blocks to the current port our PIX 501 is hanging off of. I would like to be able to facilitate a smooth transition between IP Blocks, so I would like to have both blocks available ...
I have setup a point to point VPN from a PIX 515e running 6.3(4) and a Cyberguard SG300. I can connect and communicate for a few minutes, but then I get "disconnected" though the cyberguard shows the tunnel is still running. I get this in my Pix Sysl...
Thanks...the only reason I really asked is that the two other tunnels I have to this ASA don't seem to re-establish like that, they seem to be always on.
Jorge,Thanks for the response. They are letting us keep both blocks for a little while to ensure a smooth transition. The current outside route is:route outside 0.0.0.0 0.0.0.0 66.101.xxx.xxx 166.101.xxx.xxx = the current gateway for the current IP b...
The 2950 (WS-C2950-12) should handle task without a problem right, no special accessories or software?I think the hardest part of this will be getting the Data Center to run HSRP or VRRP on their GSRs for me
