Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have an old 2514 running Version 11.0(10c). I have a couple problems. 1) The router does not seem to be routing between the two ethernet interfaces. And 2), how to I reset my passwords so that they are blank? Output from show running-conf...
Hello,I was told by a co-worker that Cisco makes IOS downloads available for no charge if the device is no longer supported or has reached the so-called end of life. I have a 2514 that I got from EBAY. It has IOS v11.2(10a), as seen below in the ou...
Hello,I have a 2514 with 2 ethernet interfaces. They are config'd as:e0: 192.168.1.1 255.255.255.0e1: 192.168.2.1 255.255.255.0For some reason, there is no routing taking places. Following is my running-config. I am a newbie so can anyone tell me ...
Hello,Newbie question. How do I completely clear/delete the current running-configuration on a 2514? I want to start the router config totally from scratch.TIA,Rich
Hello,I am a IOS beginner and I recently purchased a 2514 from EBAY. I would like to deploy it on my Windows-based home network. Would simply like to route between 2 network segments but don't know how. Can anyone help me with the configuration? ...
Thanks everyone,I am certainly learning. I have come across a problem however. I can't see where I'm actually routing. I can't ping from 1 side of the router to the other. Below is output from "show running-config". Everything was config'd from ...
You're right. The last line in the config is a "login". My network is at home and the config will likely be changed often as I am just trying to learn and try new things. I'll try your suggestions and reply hopefully this afternoon.Thanks again,Ri...
Thank You,I think that will do it.I have one additional question.When I telnet to the router from a DOS prompt, I get the following message:"Password required, but none set.Connection to host lost."I also get the same message if I connect to the rou...
