Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All, I am in need of some help. I have setup a Cisco ASA on AWS and I have VPN connecting to other side for my customer. VPN established successfully but I cannot route my inside EC2 instance for the internet through ASA. I did tried to put nat...
Hi,
Our Infosec team send us a vulnerability list, in which one was disable ntp queries.
Currently i dont have an acl on ntp, it is just configured as
ntp server x.x.x.x source port-channel 1.1
How do i disable ntp queries and what all command i ne...
Hi,
I have couple of ASR's in my production and most of them are running encryption and throughput license's namely SLASR1-AES and FLSA1-1x-2.5-20G.
I want the serial information from the configuration file. or atleast want to know which device is r...
I have a very old router 1721 which is currently running frame relay on WIC card and i have to move to the new router ISR 4331. Does ISR supports T1 WIC card? And can i configure frame relay on top of it?
ISR is running the latest IOS which i gues...
Thank you @Rob Ingram and @MHM Cisco World for the detailed explanation. I did put in nat Statement as you recommended and it did not dropped the VPN traffic and seeing hits on NAT translations as well. But still the same host (which is used by VPN)...
@MHM Cisco World What would be my <host> be in this case? Would it be my Outside interface IP or the IP that I define in access-list ?Coz I did put my Outside interface IP and it did not work.
