Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I've been working on this for 3 days and no resolution. Hopefully some smarter folks here will throw me a bone!I have a hub and spoke phase 3 topology that works great except for speed- internet speeds (DIA) are as expected, spoke is 100M and hub...
This should be a question with an obvious answer but the Google Gods haven't been clear. I'm trying to determine which image I need for a 3702i access poing with the master controller AP (mobility express) running 8.8.125 but can't seem to find anyth...
Hey, thanks for following up- not yet, we're moving some data center DR equipment this week (last minute, as always) and it's been eating up all my time. I do plan on picking this up this weekend though. Appreciate it!
Hey, thanks! Good info- the default route was from an old test propagating a default route from the spoke and not needed and now removed. And thanks for the vty note, I missed that when I posted the configs- it's now changed on the boxes. I did swap...
Haven't yet- I did remove the crypto on the tunnel entirely for a test, however with minimal difference. Oddly enough, the average was just slightly slower with no crypto.
Thanks- some of those were leftover configs from past testing, I cleaned them up along with some of the old routing info that's not needed. I've also changed this hub from the original 881 to a 2921 and gotten rid of the vlan stuff completely- it's n...
Sure!Hub:AB-Lab-2911-Gateway#sh int sum*: interface is upIHQ: pkts in input hold queue IQD: pkts dropped from input queueOHQ: pkts in output hold queue OQD: pkts dropped from output queueRXBS: rx rate (bits/sec) RXPS: rx rate (pkts/sec)TXBS: tx rate ...
