About mwickings

mwickings · 09-23-2004

Hi,I have a 3 site triangle, with a 2621, an 827 and a SOHO97, all have a link to each other, but when i try and do rip routing - it only works between the 2621 and the 827, the soho97 only seems to take part when it is seeing the RIP traffic via the...

mwickings · 09-27-2004

Yup that was it, ha i did not see that i had put the 80.x.x.x network in there, in my brain it was reading 82.x.x.x - thanks for pointing that out, it all seems to work now!! at lastThanks very much!Mark

mwickings · 09-24-2004

yeah i ran it through the cisco interpretor, see my other post. Looks like a bugI did a no router rip and then re-applied it, but still no avail. the tunnel permits ip any any, so i doubt it that, i have also tried running it in just GRE tunnel mod...

mwickings · 09-24-2004

I Put this through the cisco out interpreter and it said:-STACK DECODE NOTIFICATIONS (if any)The failure was caused by a software defect.The stack trace decoded symbols are: rip_sendupdate_vk rip_sendupdate_subr rip_sendupdate pdb_majorupdate rip_pr...

mwickings · 09-24-2004

I did not think of the neighbor thing, but i have added the statements and it still does not work. I also discovered some new interface commandsint tu1ip rip send ver 2ip rip receive ver 2But still the router sees nothing from them, check the debug ...

mwickings · 09-24-2004

The output of show ip protocol that you posted indicates that there are 6 active neighbors. Did that come from the SOHO router?Yes, but it was from the LAN, not the tunnelsdebug ip rip:Sep 24 12:14:52.869 UTC: RIP: Update sent via Ethernet0Sep 24 12:...

Member Since	‎09-23-2004 03:33 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	8

User Statistics

User Activity

RIPv2 over Tunnels

Re: RIPv2 over Tunnels

Re: RIPv2 over Tunnels

Re: RIPv2 over Tunnels

Re: RIPv2 over Tunnels

Re: RIPv2 over Tunnels