Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have installed new MSTP systems. The documentation is very unclear on when timing is needed on MSTP. In fact, we have been told that transpondes do not need timing at all, for they recover timing from the Rx OC stream. Does anyone have any expe...
Typically you don't mix them. In MSTP there are no XC cards, so that takes care of MSPP cards in MSTP. Transponders can go in any shelf, since the shelf is just a way to talk and control the card; I believe amps and pre-amps will work (in MSPP), bu...
The best way to look for cross connects is via TL1. Open the TL1 window and log in:act-user:::$::;rtrv-crs:::$;The hard part is getting the AID correct. For example, the old style OC48 cards would be "STS-6-1-all". You will have to spend some time...
Here is some of the info you are looking for:This is number of rings (Path protected) path protection with SDCC 34path protection with LDCC 14path protection with LDCC and SDCC 26This is just part of the information. Read all of ...
You can re-arrange all you like, just make sure that when finished there is an east/west relationship between nodes; it doesn't matter which slots are east or west, but east must face west and west must face east. While you are making the changes th...
