About joeevans

joeevans · 09-11-2006

About 6 months ago I finally got round to upgrading 2 of our pixes to 7.1 from 6.3. I didn?t use them until the other week when I found that the activation keys were no longer valid. After investigating I found that they needed to be upgraded troug...

joeevans · 09-29-2004

HI,> > I've just set-up two PIX525 firewalls with stateful failover and they > seam to be working correctly except that I am get the message..> > Warning, missing ip or failover address on the inside interface> > The inside interface has an ip addres...

joeevans · 03-20-2008

YOu can hard set them but you need to do it at both ends. Are you sure it's not a cable or MDI/MDIX problem?

joeevans · 03-20-2008

have you tried a stander RS232 cable?

joeevans · 03-20-2008

what device are you using? do you mean vtp?

joeevans · 03-20-2008

YOu will need to use cross over cables unless you can alter the MDI-MDIX settings. You should also fix the speed/duplex to 100/full on all ports.

joeevans · 08-18-2007

I have the same problem, did you ever get to the bottom of it? The one thing I have found is that in show ver the problem router has MPC860P processor: part number 0, mask 32where as one that works hasMPC860P processor: part number 5, mask 2maybe it...

Member Since	‎09-29-2004 04:40 AM
Date Last Visited	‎09-28-2018 12:06 AM
Posts	14

User Statistics

User Activity

Pix 515e 6.3-7.1 upgrade activation key problem.

Pix Failover anoying message

Re: Auto of not?

Re: Connecting two (2) Cisco 3270 routers via their 9 pin serial

Re: vlan ftp combination

Re: Urgent help. Etherchannel

Re: URGENT:i CAN'T SET VLAN ON 1721