When I telnet to one of my remote routers the only thing that comes back is the banner. I do not get a prompt for a username? I have checked my ACS server and it is functioning properly. I have also checked that I can ping the other side of the route...

when using the ip audit command and subinterfaces. where do you place the ip audit command? Can you place it on the physical interface and have it check all traffic or does it need to be applied to each sub-interface individually?

Has anybody seen a situation where IDS configured on a router slows down active x apps? I enabled IDS on a few routers we have and all of a sudden certain apps like TrackIT started to take an additional 45 seconds to load. Turn IDS off and everything...

This may be a dumb question, but can you do router on a stick with a 1720?I have enabled ip routing, version is 12.27 ip/ids/fw. Every time i try to assign encap to a sub interface it recognizes the encap command until it comes time to tell it what t...

anybody know the throughput in Kpps of the 2851? Trying to do a comparison for an upcoming upgrade. I have been all over this stupid site and haven't found it.