Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Recently, within the last week we've begun having an issue at one of our customer sites with an ASR 1001-X running IOS-XE Everest 16.6.4 (See below for exact IOS). The symptom is that when using the 10G port Te0/0/1 which connects to the ISP's fiber ...
You could use an ISR 2821 with a NM-32A card. Here's a link to one on eBay. https://www.ebay.com/itm/CISCO2821-K9-Router-with-NM-32A-1GB-256F-CISCO-2821-Terminal-Access-Server-/282672010097
Yes you can. As an example, here is one that I wrote to send a trap when a link reaches 50% utilization. event manager applet HFC_UTILIZATION_50%event interface name GigabitEthernet0/1/7 parameter rxload entry-op gt entry-val 128 entry-type value po...
Little bit of an old thread, but didn't see a resolution. However, in order for traps to be sent by the event manager the following has to be enabled in the snmp-server configuration on the device snmp-server enable traps event-manager "If the action...
Pattyj,In your configuration:no event manager applet EM-CHECK-FEXevent manager applet EM-CHECK-FEXdescription "Checks FEX for availability because no trap would be sent"event syslog occurs 1 pattern "FEX-2-NOHMS_ENV_FEX_OFFLINE"action 1.0 snmp-trap s...
