pattyj
Level 1
Level 1
Member since ‎06-14-2004
‎02-05-2024

User Statistics

  • 35 Posts
  • 1 Solutions
  • 20 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Discussion Posts
30 Discussion Posts
20 Discussion Posts
First Discussion
First Question
10 Discussion Posts
1 Reply
CCP Member
1 Accepted Solution
10 Replies

User Activity

Hello Community, Is there a correct syntax to add multiple eem built in variables to a single statement like below if supported? action 2.0 snmp-trap strdata "$_syslog_msg, $_info_routername"oraction 2.0 snmp-trap strdata "$_syslog_msg / $_info_route...
 I'd like to use this config for EEM in the Nexus 5K. The Nexus only takes the first event syslog occurs statement so I don't understand why it's losing the 2nd statement. See below for sh run eem. Nexus 5548 version 7.0(7)N1(1).  Am I violating a sy...
How can I find the running Prime job via the Prime CLI?  Assuming there is a PID per each job that can be manually killed.  Ran a system reboot job that was reloading routers.  Prime said the job stopped or timedout but routers were still rebooting a...
Is it possible to create a custom dynamic IOS software version Dashlet in Cisco Prime.  So idea is a user can select a device family and see software versions on that device familiy dynamically.  A visual on demand interactive dashboard for IOS versi...
Trying to use CLI Templates to push this command to a bunch of ISR4Ks but it has a yes/no prompt that needs a response so trying the #INTERACTIVE option but have not gotten it to work. Tried various permutations but they all fail.  There is not much ...
Community Statistics
Member Since ‎06-14-2004 11:51 AM
Date Last Visited ‎02-05-2024 12:29 AM
Posts 35
Helpful Votes Given To